Arturia Forums

Hardware Instruments => PolyBrute => PolyBrute - Technical Issue => Topic started by: statlerw on February 19, 2022, 08:13:45 am

Title: How to tell what the Motion Recorder setting is doing
Post by: statlerw on February 19, 2022, 08:13:45 am

I am just trying to figure out how I can tell what the recorded MotionRec is doing in a patch. Basically I have a patch that I want to modify, but the bit I want to modify is a motion record, and it isn't my patch. It seems like it is doing 2 things, but as far as I understand, the motionrec is only able to modify one paramter. Is there any way to determine what parameter(s) the motion recorder is changing?

I have looked in Connect and couldn't see anything changing. There is nothing in the matrix that explains the full difference in the patch between when the Motion Rec function is set to  Off vs Once

Title: Re: How to tell what the Motion Recorder setting is doing
Post by: larioso on February 19, 2022, 05:20:14 pm

If you press the Motion play button to once or loop, it will tell which parameter it has recorded.

Have fun....

Title: Re: How to tell what the Motion Recorder setting is doing
Post by: statlerw on February 22, 2022, 10:59:42 am

Huh. Can't believe I didn't notice that. You rock.