Arturia Forums
Hardware Sequencers => KeyStep Pro => KeyStep Pro - Technical Issues => Topic started by: DDRRecords on January 09, 2022, 08:55:44 pm
-
Heya,
So I'm having issues keeping the synths separate.
I got 0-Coast plugged into midi 1, Quadrantid Swarm plugged into midi 2, Track 3 has the DFAM from gate to advance .... MIDI one playes at the same time. The tracks are set up for separate midi channels. 1 for global 1, 2 for 2, 3 for 3 ... you get the picture...
I've tried swapping the synths over... same issue...
I've reset to factory settings, no difference..
Am I missing something?
Please help
Thanks
DDR
-
Hi same thing appears to be happening with me. Just bought keystep pro, updated to the latest firmware. So far so good, hooked KSP up to my synths (o-coast,sub37,Westpest, drums). Midi settings as expected. the o-coast will control fine then just disappear, I check the midi setting and nothing has changed, just kinda drops out. The sub37 has been fine with no issue and the west pest will not receive at all.
I tried moving things around midi channel wise but nothing helps, it seems if I do a factory reset then the 0-coast will be controlled again for some time, then drops out (again no changes to midi settings just factory reset)
* I have only had the KSP for a few days, I am coming to KSP after having a keystep and beatstep pro so I am fairly familiar with Arturia equipment but never ran into this type of issue.
I know if I was reading this post I would think set up issue. but I have triple checked and all is as it should be. I'd appreciate any help with this if anyone else has encountered it
-
Well, it turns out it was a bad midi through box with a few outputs not working correctly, nothing to do with KSP. Once this was resolved my Keystep Pro appears to be working correctly. Coming from a beatstep pro and keystep, I am really enjoying the KSP so far.