Arturia Forums

Hardware Instruments => PolyBrute => PolyBrute - Feature requests => Topic started by: larioso on November 18, 2021, 11:01:48 am

Title: Expression 1 or 2 for Master cutoff does not show where if touching master knob
Post by: larioso on November 18, 2021, 11:01:48 am

Touching Master Cutoff knob and lets say it is zero.
There is a popup showing where it is just touching it between +/- 100.

#1. Moving an exp pedal connected to Master Cutoff and then touching Master Cutoff knob I think it should show where it is as starting point. But it always show last value as knob was touched. You have no clue where it is really.

#2. Master Cutoff also does not work as show stored value using the Preset button + touching Master Cutoff.
You override with the popup showing Cutoff position instead.
I assume Master Cutoff as starting point is stored with preset.

Thanks for any support on this.