Arturia Forums

Hardware Sequencers => KeyStep Pro => KeyStep Pro - General Discussions => Topic started by: scab righteous on May 10, 2021, 12:00:22 am

Title: New to Keystep Pro - have a few questions
Post by: scab righteous on May 10, 2021, 12:00:22 am

I have a few questions about the Keystep Pro.

1) How do you quantize a sequence, after recording it unquantized?
2) Is there a way to know when an edit is permanent, and 'undo' can't be used. Clear pattern can be undone, but Clear All Steps can't. Not sure if there is some logic to that?
3) Is there a way to limit the range of 'random' when you use "random notes". Does it only use random notes in the key/scale?

I read the 2.0 manual before buying, and was pleasantly surprised that it does stuff I use, which the manual says it can't. For example, you can save chords you set up in chord mode. The Hold button will allow you to hold a note without an arp running.

Title: Re: New to Keystep Pro - have a few questions
Post by: Adrien_Arturia on May 10, 2021, 11:15:39 am

Hello!

1) By Pressing shift + 'Qnt 50%' (or 'Qnt 100%')
2) Undo works for Clr Ptn, Erase Ptn (project, page, steps, etc...), Paste Ptn -> The memory structure of KSP
3) There is no way to limit the range of random but it randomize notes within the scale yes. Also it randomize only the active steps + the steps that are within the lst step (does not randomize the one after)

Hope it helps,

Best,

Adrien