Arturia Forums

Hardware Sequencers => KeyStep Pro => KeyStep Pro - Technical Issues => Topic started by: bdrank on September 08, 2020, 12:45:29 am

Title: Step-time recording still stops working (step does not advance) on 1.3.1
Post by: bdrank on September 08, 2020, 12:45:29 am

On version 1.3.1

Step sequencer still does not advance after playing around on a track, i.e.:

1. Press record for step-time sequence while sequencer is not running.
2. Pressing any keys will only change the value for step 1. It does not advance past step 1.

This is the behavior on ALL tracks. Step-sequencer (putting in notes SH-101 style) basically doesn't work at all.

I'm not exactly sure what's causing this issue, though I suspect it's after using scale modes on a track.

This has been an ongoing bug since last firmware which is a bit frustrating, as the only remedy to fix it is to power-cycle the unit.

It's a consistent bug as it happens pretty much every time I use the KSP.

Title: Re: Step-time recording still stops working (step does not advance) on 1.3.1
Post by: synthcreep on September 08, 2020, 01:52:07 am

This still happens for me with 1.3.2 after a factory reset.  If you haven't already, I would suggest opening a ticket with support.

Title: Re: Step-time recording still stops working (step does not advance) on 1.3.1
Post by: bdrank on September 08, 2020, 11:27:32 pm

Quote from: synthcreep on September 08, 2020, 01:52:07 am

This still happens for me with 1.3.2 after a factory reset.  If you haven't already, I would suggest opening a ticket with support.

Updated to 1.3.2 today, but still run into the issue not long after making some patterns.

I imagine Arturia is already aware of this issue as I'm not using the KSP in any unordinary way. Just making some patterns with and without scale modes, then step-sequencer stops working.

I suppose I'll submit a support ticket anyway to be sure.

Title: Re: Step-time recording still stops working (step does not advance) on 1.3.1
Post by: al80 on September 12, 2020, 03:39:42 pm

weird.i updated my ksp yesterday with firmware 1.3.2(build 657)and it is working fine .i tried step recording with scales selected over 30
 times and the bug did not occurred.i guess the bug has fixed.

Title: Re: Step-time recording still stops working (step does not advance) on 1.3.1
Post by: bdrank on September 16, 2020, 09:02:58 pm

Had to do a factory reset here on 1.3.2. So far so good. No issues with step record so far.

Title: Re: Step-time recording still stops working (step does not advance) on 1.3.1
Post by: bdrank on September 16, 2020, 10:57:04 pm

I've spoke too soon..

After playing the KSP about an hour or so, using scale modes, making patterns, deleting patterns, etc, step sequencer stops working again.

Same behavior as before. Step-time recording does not advance when playing notes.

Title: Re: Step-time recording still stops working (step does not advance) on 1.3.1
Post by: synthcreep on September 17, 2020, 03:40:33 am

Happened to me again today as well:

https://youtu.be/0jEgeF6a69U

Note I am not doing anything with scales (at least intentionally).