Arturia Forums

Controllers => KeyLab MkII => KeyLab MkII - Technical issues => Topic started by: joelstewart88 on June 13, 2020, 06:19:04 pm

Title: Logic 10.5.1 and Keylab 61 MKII
Post by: joelstewart88 on June 13, 2020, 06:19:04 pm

So far I have been unable to get my new Keylab 61 MKII to work as a control surface inside Logic 10.5.1. I have tried following the directions listed here: https://www.arturia.com/faq/keylabmkii/keylab-mkii-tips-tricks

I want to use the Keylab transport controls and the DAW command buttons.

When I add the Mackie Control surface in Logic I am unable to Right-Click on the controller icon to click the Inspector. When I try right-clicking, a yellow line appears and then disappears to the left of the icon.

Any help you can provide will be much appreciated.

Title: Re: Logic 10.5.1 and Keylab 61 MKII (SOLVED)
Post by: joelstewart88 on June 14, 2020, 03:00:16 am

I found the solution to my problem. Advanced Tools MUST be enabled.

Go to Logic Pro X/Preferences/Advanced Tools - Select ENABLE ALL

After I did this I was able to follow the instructions here:
https://www.arturia.com/faq/keylabmkii/keylab-mkii-tips-tricks

Everything works correctly now.

Title: Re: Logic 10.5.1 and Keylab 61 MKII
Post by: bradd on July 19, 2020, 01:52:36 am

Joel, I just got the Keylab and am having problems.  If I set it up to map any soft synths other than Analog Lab, I lose the ability to control the faders in Analog Lab. Have you encountered this problem?