Arturia Forums

Hardware Instruments => MiniBrute 2S => MiniBrute 2S - General Discussions => Topic started by: ThinkerThunker on April 18, 2020, 04:53:09 am

Title: Recording filter movements
Post by: ThinkerThunker on April 18, 2020, 04:53:09 am

Hi. How do you record filter changes so that it plays along with a pattern?

Thanks

Title: Re: Recording filter movements
Post by: psienide on April 19, 2020, 04:32:54 am

You'll have to use the mod tracks. You can set either one (or both) to envelope, lfo or a voltage and then patch that into the cutoff, fm, rm.

Also cutoff is normaled to the pressure track, so setting a higher pressure on a step will open the filter more with the attenuator set appropriately. But I think using env or lfo on the mod tracks is more musical.

Title: Re: Recording filter movements
Post by: ThinkerThunker on April 19, 2020, 11:04:01 pm

Hey Psienide, thanks for the reply.

I had some success adjusting Press values (Pressure) per step, then cranking Alt 1 - Cutoff which is triggered by Pressure. That might be as close as it gets to "per step" Cutoff settings.