Arturia Forums

Hardware Sequencers => KeyStep => Keystep Technical questions => Topic started by: gadgetman2000 on February 07, 2020, 07:53:33 pm

Title: Mod strip setup
Post by: gadgetman2000 on February 07, 2020, 07:53:33 pm

I'm struggling to get the mod strip to operate any hardware or software.

With the Keystep connected and MidiControl Centre open, if I use the mod strip Control Centre shows that it is seeing it as the green 'down arrow' lights up, so I know the strip is working.

However, if I have the Keystep set to control, say Arturia Mini V, the mod strip does not control the mod wheel on the synth. The pitch strip works fine, moving the pitch bend wheel as you would expect.

Both mod and pitch are set with 'user' as the midi channel

Am I missing something obvious?

Thanks!

Title: Re: Mod strip setup
Post by: vyanezf on August 05, 2022, 07:16:23 pm

I think it is not config, it's troubleshoot.
I have the same problem.
Through midi monitor I can see the numbers running as expected, but no software or hardware is reading the CTL info as is .