Arturia Forums

Hardware Instruments => MatrixBrute => MatrixBrute - Technical Issues => Topic started by: Bitflipper on March 07, 2017, 09:27:49 pm

Title: Glide on/off switch does not work when Sequencer is active
Post by: Bitflipper on March 07, 2017, 09:27:49 pm

When Sequencer is active, the Glide on/off button does not work.
I know you can program glide on/off per step in a sequence, but also in sequences without glide steps programmed, the switch does not toggle.
If you (temporarily) switch off Sequencer, you can toggle Glide on/off, and switch on Sequencer again.
In my opinion the Glide on/off button should always work, no?

Title: Re: Glide on/off switch does not work when Sequencer is active
Post by: Edouard_Arturia on March 10, 2017, 03:07:49 pm

Hello.

In my opinion this is normal.

Otherwise, it would conflict with the Glide ON/OFF applied the sequencer isn't it ?

Kind regards

Edouard

Title: Re: Glide on/off switch does not work when Sequencer is active
Post by: Bitflipper on March 11, 2017, 08:38:11 pm

Hi Edouard,

Thnx for your reply, but I only partially agree:
A lot of sequences do not have (any) glide steps, and you might want to switch a general portamento to the sound on and off while playing.
The sequencer glide steps control / override the glide switch anyhow, so there would not be a problem with adding this possibility.
Just a suggestion, no big issue.

Kind regards,
Aard

Title: Re: Glide on/off switch does not work when Sequencer is active
Post by: Edouard_Arturia on March 14, 2017, 10:04:02 am

Hello Aard.
Hope you are doing fine.
I see, apply glide on the whole sequence can be long.
I will submit a feature request to allow to place glide on parts of the sequence the same way you place tied notes.
(Press & hold the first step, then press the second to apply glide on the whole section)
Best Regards.
Edouard