Arturia Forums
Hardware Instruments => MatrixBrute => MatrixBrute - General discussions => Topic started by: Rickz on July 09, 2019, 07:22:22 am
-
Dear members,
I have recently gotten my hands on a secondhand Matrixbrute that I am extremely happy with, yay! ;D
Unfortunately the previous owner was a smoker and some of the white buttons including the 256 matrix buttons have gotten a bit yellow because of that and I think I should try to clean that up.
Have any of you ever cleaned the device? Can you recommend me a method and tell me what to use to get that cleaned up.
Any advice is very welcome.
Thanks in advance, kind regards.
-
Take your matrixbrute out into the yard, chain it down so it doesn't escape, hose it down with cold water, making sure you get in-between all the buttons, let it shake itself dry, then just towel it down.
-
But seriously . . .
For plastics warm soapy water is probably your best approach, you might want to remove all the knobs first before washing them.
-
I am not a smoker and my Matrixbrute knobs are turning off colour too, a red/yellow colour. I am always sure to keep my hands clean before I touch any of my gear. I assume most people will have this happen to theirs as it gets older.
-
Thanks guys, I thought maybe with 100% alcohol but if you guys clean it with soap, i'll give that a gentle try.
Thanks!
-
I'd be a lot more worried about those gunky smoke molecules that have seeped inside the unit.
Good luck, hope you got a super nice price!