Arturia Forums

Hardware Sequencers => BeatStep Pro => Beatstep Pro - General Discussions => Topic started by: ozmic on February 03, 2017, 07:48:28 pm

Title: BSP with RX7
Post by: ozmic on February 03, 2017, 07:48:28 pm

I hooked up a Yamaha RX7 with the BSP.
In Drum mode when I hit the pads I get a series of voices.
There are 99 voices available in the RX7 but I can not seem to change the selection I get in the BSP. I get the same 16.
Is there anyway to change these?
Cheers.

Title: Re: BSP with RX7
Post by: megamarkd on February 04, 2017, 01:45:46 am

You can change which notes are sent by the BSP's drum pads in MCC.

Title: Re: BSP with RX7
Post by: ozmic on February 04, 2017, 12:54:41 pm

Thanks for the response.
The manual does not explain much and the video by Arturia shows the BSP drum part with software which does not help.
I assumed I should go to Device settings > drum map > Custom> then change the numbers which looks like they only change velocity or similar as they go to 127.
When I do that nothing changes.
In Controller Map if I click pad 1, and used trial and error changing many different parts like play mode and notes for example nothing changed.
Also in control mode on the BSP I can not change the drum sounds going through these pads.
Where exactly would I change settings?


Edit: Just tried this with a TR-8, 626 and a 707 and in drum map > custom > I can change the value and the drum voices change. So it is something on the RX7 side.
EDIT: Just tried the RX7 again and it worked. Very strange.
Cheers.

Title: Re: BSP with RX7
Post by: megamarkd on February 06, 2017, 11:13:35 am

Cool!
I still think of a sleek, low, red Japanese sports car from the 80's when I read "RX7", heheh.