Arturia Forums
Hardware Sequencers => KeyStep Pro => KeyStep Pro - Technical Issues => Topic started by: Kparke1555 on June 14, 2022, 06:14:57 am
-
My 6 mo old KSP CV outs all went dead while testing it with 2 Behringer 2600's used as euro mods. I was testing a midi issue in the 2600's, (2600 won't change pitch below C4) which worked fine through the CV's. Then I made some tweeks to the midi outs in manual mode to try to correct the problem and then it just started sending a low frequency pulse out of the CV's, maybe 20hz or less. All 4 chns.. Tried rebooting, tried going back to 2.0 firmware, then back to current 2.01. Nothing... Anyone one have any ideas???
-
I was lucky with a factory reset. But yeah it just happened to me too. A cv was sent out, just it wasn't modulated or responding to anything.