Arturia Forums

Hardware Sequencers => BeatStep Pro => Beatstep Pro - General Discussions => Topic started by: maddyman on June 03, 2017, 09:17:03 pm

Title: Does the BSP accept MMC (MidiMachineControl) commands?
Post by: maddyman on June 03, 2017, 09:17:03 pm

Hi
I would like to remote control the start and stop of the BSP via MMC (Midi Machine Control) commands.
Bescause there are no other ways to let the BSP starts and stop at different and multiple points of my Logic arrangement.
Is there any way to do this by the MMC commands?
Somebody in the Logic Forum supposed this could be working fine (if the BSP recognizes these commands)
thank you for any advise
regards

Title: Re: Does the BSP accept MMC (MidiMachineControl) commands?
Post by: megamarkd on June 14, 2017, 12:03:41 pm

Yes, it does accept and recognise MMC messages.  It's in the manual.

Title: Re: Does the BSP accept MMC (MidiMachineControl) commands?
Post by: I grec on September 29, 2017, 09:50:13 am

Hi guys,
No it does not recognize MMC as input commands. At the moment, the BSP can only send MMC commands (MIDI out and USB). Maybe a future update will allow it as input too (MIDI IN and USB).
Y.