Arturia Forums
Hardware Sequencers => KeyStep => Keystep Technical questions => Topic started by: flat_land_cycle on September 22, 2017, 04:14:07 am
-
I'm working on KeyStep setup in the MIDI Control Center. So far no notes lower than C4 will play on my KeyStep. I can't figure out the logic on this.
This is from the chart on Page 64 of the Manual:
Transpose Center Pitch | Full MIDI note range | Notes above/below center transpose the sequence up/down
I have no idea what "Notes above/below center transpose the sequence up/down" means.
The Drop Box (data field) only has notes like C-1 to like C8.
I think the problem is with what belongs in "0V MIDI Note" text box and what belongs in "Transpose Center Pitch" text box. I have yet to find the correct combination. I have a Moog M-32 that wants 0V for C4, in CV out mode, not MIDI. C4 doesn't seem to work in "0V MIDI Note" field. All help would be appreciated.
-
Additional info:
All notes including Transpose lower Octaves output 0V from the PITCH out. There are no longer negative voltages from the CV out.
-
Mh, keystep does not output negative voltages, so you need some kind of adapter, can't you use midi instead?
-
The problem lies with the moog set on OV C4, thats just too high. Should be OV for CO in most Eurorack i believe.
there is a CV AT O Volt field, did you try choosing C4 there?